Corso Milano 14
20837 Veduggio con Colzano
Tel ++390362910763
Fax ++390362911255
www.dgts.it - e-mail: info@dgts.it
Pec: dgts@legalmail.it
Codice Fiscale e Partita Iva IT 10785460154 - Registro delle Imprese 10785460154 - REA MB 1407783 - Cap. Soc. € 90.000,00 I.V.
Automotive
Cosmetica
Alimentare
Metalli
Carta e Cartone
Plastica
Gomma
Tessuti
Edilizia
Farmaceutico
Medicale
Packaging
Tubi PE-PVC
Molle
Adesivi
Provini
Microscopi

Abrasion Cut an Chip Tetser

The Cut and Chip Tester CC 3000

CC 3000 was developed to predict the service performance of passenger, truck, OTR, farm, mining and industrial solid tires, tank tracks and bogey wheels, as well as industrial products such as conveyor belts that are subjected to contacting surfaces containing sharp objects (rocks, gravel, glass, metal, etc.).
The test is designed to be quick, inexpensive and furnish a high level of confidence in predictive testing of actual product performance.
The Cut and Chip Test is performed on acured rubber disc specimen mounted on a rotating spindle. The disc is impacted by a tungsten carbide knife with a precision ground cutting edge. An eccentric cam applies the knife at a specified frequency for a specified time, both of which can be set according to the application requirements.

The CC 3000 is conveniently controlled by a integrated 7“ Touchscreen panel with a preselection of 11 different spindle speeds and 7 different chipping cycles providing the operator with quick and easy test setup possibilities. All speeds are digitally controlled by servo motors – for safety the instrument is fitted with a supervised safety door. The motorized cam conveniently lifts the knife support arm at the completion of the pre-selected test time.
The resistance to cutting and chipping is based upon the loss of material (mass and reduction of disk diameter) over the duration of the test.

----------------------------------------------------------------------------------------------------------------------------------------------------------------

Consumables, reference samples and sample preparation accessories (optional):

- Set of control samples
Set of 5 certified control samples including test certificate

- Set of Tungsten carbide knifes
Set of 5 certified Tungsten carbide knife inserts for the CC 3000

- Precision scale with 1mg or 0.1mg resolution
For weighing of samples before and after the testing process

- 9-cavity cut and chip mould:
Mould dimensions 296 x 296mm x 50mm, Precision machined from Stainless steel Nine cavity three piece mould with centering pins and handles Specifically designed for cut and chip samples with 51 mm Ø, 13 mm Thickness, 13 mm Ø Center hole.

Dirt removal and cleaning:

  • In the standard configuration the CC 3000 is equipped with a integrated stainless steel tray for collecting any rubber dirt or risidue from the working area that is produced during testing.
  • Optionally the CC 3000 is also available with a automatic cleaning unit. This system consists of a special hopper mounted below the working area and a special vacuum cleaning device extracting all dirt and rubber particles immediately.
  • The cleaning unit is controlled by the Touchpanel and automatically switched on any during the testing sequence.